Hi, any suggestions if there may be a way to disable SNAPPING when drawing ADD SET walls and objects?? While scale isn't an issue, adding one 'wall' at an unusual angle is fine, but extending further walls and objects inside to follow an already placed angle just isn't pleasant. ie..a wing of building/set that is at 45deg...the outer walls, fine..but then constructing inner rooms and corridors at similar angles just gets messy and impossible...either remove snapping, or have it work at all most angles. Am I missing anything to be able to disable snapping??? Or is there a better way?
top of page
bottom of page
If you tap the final wall to get the popup with settings, there's a Grid Snap checkbox where you can disable snapping after the fact and then dial the wall in.